Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 226
Confidential
4.4.2.19 Cartridge Cover Sensor L
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Pull off the Pressure Tube.
5. Release the Pressure Tube from the guide on the cover of the Ink Holder Board
Assy L.
6. Disengage the two hooks that secure the cover of the Ink Holder Board Assy L,
and remove the cover.
7. Remove the six screws that secure the plate, and remove the plate.
A) Silver, Phillips, Round Washer Head S-tite M4x6: four pieces
B) Silver, Phillips, Round Washer Head S-tite M3x6: two pieces
Figure 4-44. Releasing the Pressure Tube
Figure 4-45. Removing the Cartridge Cover Sensor L
Secure the terminal of the grounding wire and the plate with the
same screw shown in the figure.
- Rear left -
Cover of Ink Holder Board Assy L
Pressure Tube
Guide
Hook
A
Screw
together
- Left side -
Cover of Ink Holder Board Assy L
Plate
B
To Next Page
Loading...
