Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 225
Confidential
4.4.2.18 Cartridge Cover Sensor R
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the Rear Cover. (p220)
6. Remove the Ink Cartridge Holder R. (p277)
7. Disengage the two hooks that secure the cover of the Ink Holder Board Assy R,
and remove the cover.
8. Disconnect the two connectors (CN408, CN409) on the Ink Holder Board Assy R.
9. Release the harness from the two hooks. See Figure 4-43.
10. Remove the two screws that secure the Cartridge Cover Sensor R, and remove the
Cartridge Cover Sensor R.
A) Black, Phillips, Bind P-tite M3x10: two pieces
Figure 4-42. Removing the cover of the Ink Holder Board Assy R
Figure 4-43. Removing the Cartridge Cover Sensor R
Cover of Ink Holder Board Assy R
Hook
Hook
- Right side -
A
Ink Holder Board Assy R
Hooks
Connectors
Cartridge Cover Sensor R
- Right side -
To Next Page
Loading...
