Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 231
Confidential
4.4.3.3 Sub Board Assy
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the IC Cover L and the IC Shaft Cover L. (p206)
6. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
7. Remove the Left Cover. (p209)
8. Remove the Top Cover. (p214)
9. Unlock the Carriage Unit. (p201)
10. Disengage the four hooks on the bottom, and remove the CR Belt Cover.
11. Disconnect all the cables and FFC on the Sub Board Assy.
Figure 4-51. Removing the CR Belt Cover
Figure 4-52. Connector locations
Hook
CR Belt Cover
CN105
CN104
CN116
CN111
CN112
CN100
CN101
CN106
CN118 CN114
CN113
To Next Page
Loading...
