Epson Stylus Pro 9900 - Page 232

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 232
Confidential
12. Unlock the Carriage Unit and move it to the left end.
13. Remove the four screws that secure the Sub Board Assy.
A) Silver, Phillips, Bind P-tite M3x10: four pieces
14. Remove the Sub Board Assy.
Connector assignment:
Note *: Epson Stylus Pro 7900/7910/9900/9910/WT7900/WT7910/7890/7908/9890/9908
only. Not used for Epson Stylus Pro 7700/7710/7700M/7710M/9700/9710.
Figure 4-53. Removing the Sub Board Assy
Secure the terminal of the grounding wire and the plate with the
same screw shown in the figure.
Connector No. Color Destination
CN100 (FFC) Main Board Assy (CN100)
CN101 (FFC) Main Board Assy (CN101)
CN104 (FFC) Main Board Assy (CN104)
CN105 (FFC) Printhead
CN106 (FFC) Printhead
CN111 Black PG HP Sensor
CN112 White PW Sensor
CN113 (FFC) Ink Mark Sensor
CN114 (FFC) CR Encoder
CN116* White Ink Selector
CN118* Yellow Ink Selector
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Sub Board Assy.
<Adjustment Item>
1. Colorimetric Calibration (Color ID)
Sub Board Assy
A
Screw
together