Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 240
Confidential
4.4.4.4 Driven Pulley Unit
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the IC Cover L and the IC Shaft Cover L. (p206)
6. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
7. Remove the Left Cover. (p209)
8. Unlock the Carriage Unit and move it to the center. (p201)
9. Disengage the four hooks on the bottom, and remove the CR Belt Cover.
10. Remove the screw that secures the CR Belt to the Carriage Unit.
A) Silver, Phillips, Bind P-tite with S.W & P.W. M4x12: one piece
Figure 4-62. Removing the CR Belt Cover
Figure 4-63. Removing the CR Belt
Hook
CR Belt Cover
CR Belt
A
To Next Page
Loading...
