Epson Stylus Pro 9900 - Page 248

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 248
Confidential
4.4.4.9 Carriage Unit
1. Remove the Control Panel.(p203)
2. Remove the IC Cover (L/R) and the IC Shaft Cover (L/R).(p206)
3. Remove the Maintenance Tank (L/R).(p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
4. Remove the Right Cover.(p209)
5. Remove the Left Cover.(p211)
6. Remove the Top Cover.(p214)
7. Remove the Ink Selector.(p300)
8. Remove the Print Head.(p270)
9. Remove the Driven Pulley Unit.(p240)
10. Remove the APG Motor.(p243)
11. Remove the APG Unit.(p244)
12. Remove the CR Scale.(p236)
13. Remove the nine screws that secure the Plate B, and remove the Plate B.
A) Silver, Phillips, Round Washer Head S-tite M3x6: nine pieces
Figure 4-79. Removing the Plate B
C A U T I O N
In the next step, after removing the Plate B the Main Frame will
drop and its weight may apply an extra load to the Carriage Unit.
Therefore, make sure to hold the cover or remove the Front Cover
(Middle) in advance. (p207) Removing the Front Cover (Middle)
will make the frame lighter and avoid extra loading to the Carriage
Unit.
A
Plate B