Epson Stylus Pro 9900 - Page 249

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 249
Confidential
14. Remove the each screw that secure the CR Stopper, and remove the three CR
Stoppers.
B) Silver, Phillips, Bind S-tite with S.W & P.W. M3x8: each one piece
15. Remove the Carriage Unit by sliding it rightward.
Figure 4-80. Remove the CR Stopper
Figure 4-81. Remove the Carriage Unit
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing or removing the Carriage
Unit.
<Adjustment Item>
1. Nozzle Check
2. Ink Mark Sensor Adjustment
3. Skew Check
4. T&B&S Adjustment
5. Absorber Position Check
6. Printhead Slant Adjustment (CR)
7. Printhead Slant Adjustment (PF)
8. Head PG Adjustment
When replacing or maintaining the Carriage Unit, carry out the
specified lubrication if necessary. (See Chapter 6 "
MAINTENANCE "
(Page 444).)
Lubrication
Lubrication
B
CR Stopper
B
B
CR Stopper
CR Stopper
Carriage Unit