Epson Stylus Pro 9900 - Page 253

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 253
Confidential
4.4.5.3 Driven Roller Release Motor
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Remove the Rear Cover. (p220)
5. Disconnect the connector from the Driven Roller Release Motor.
6. Remove the two screws that secure the Driven Roller Release Motor, and remove
the Driven Roller Release Motor. See Figure 4-82.
A) Silver, Phillips, Pan S-tite with S.W & P.W. M3x6: two pieces
Figure 4-87. Disconnecting the connector
Figure 4-88. Removing the Driven Roller Release Motor
- Rear left -
Driven Roller Release Motor
Connector
Driven Roller Release Motor
A
- Left side -