Epson Stylus Pro 9900 - Page 255

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 255
Confidential
4.4.5.5 Rewind Unit
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the Spindle Cover R. (p215)
6. Release the harness from the clamp, and disconnect the connector from the
Rewind Unit.
7. Remove the three screws that secure the Rewind Unit Mounting Plate, and remove
the Rewind Unit Mounting Plate.
A) Silver, Phillips, Bind machine screw M3x6: three pieces
8. Remove the two gears from the Rewind Unit Mounting Plate.
Figure 4-90. Removing the Rewind Unit Mounting Plate
Figure 4-91. Removing the gears
C A U T I O N
The Rewind Unit is established as an ASP including the mounting
plate. When replacing this part, transfer the necessary items or
replace the whole unit.
Clamp
A
- Right side -
Rewind Unit
Rewind Unit Mounting Plate
Connector
Gear
Gear
Rewind Unit Mounting Plate