Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 260
Confidential
17. Move the carriage over the platen.
18. Remove the five screws that secure the Cutter Unit.
D) Silver, Phillips, Round Washer Head S-tite M3x6: five pieces
19. Slide the Cutter Unit to the right to detach the left side of it from the main body,
then disconnect the connector of the Cutter Motor.
20. Remove the Cutter Unit while pulling out the harness.
Figure 4-98. Removing the Cutter Unit
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing or removing the Cutter Unit.
<Adjustment Item>
1. Cut Position Adjustment
Connector
Cutter Unit’s Motor
Cutter Unit
Cutter Unit
D
Cutter Unit
To Next Page
Loading...
