Epson Stylus Pro 9900 - Page 267

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 267
Confidential
9. Remove the two screws that secure the AID Board Cover, and remove the AID
Board Cover.
A) Silver, Phillips, Bind machine screw M3x8: two pieces
10. Disconnect the connector (CN2) on the AID Board.
Figure 4-109. Removing the AID Board Cover
Figure 4-110. Disconnecting the connector on the AID Board.
After installing the AID Board Cover, check the status of the cable
connected to the CN2 on the AID Board, and if the black and white
cables can be seen, place the white one over the black one.
<Black and white cables are hidden>
No treatment required
<Black & white cables can be seen>
Place the white over the black
A
AID Board Cover
- Top right -
CN2
AID Board
- Top right -