Epson Stylus Pro 9900 - Page 268

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 268
Confidential
11. Remove the three screws that secure the plate, and remove the plate.
B) Silver, Phillips, Bind machine screw M3x6: three pieces
12. Remove the screw that secures the Ink System Unit.
C) Silver, Phillips, Round Washer Head S-tite M4x6: one piece
13. Hold up the Ink System Unit to disengage the hook from the main body, and
remove the Ink System Unit.
Figure 4-111. Removing the Ink System Unit
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Ink System Unit.
<Adjustment Item>
1. Counter Clear (Wiper)
2. Counter Clear (Pump Motor)
3. Cleaning PG Adjustment
4. AID Function Check
C A U T I O N
The Ink System Unit as an ASP does not include the Wiper Cleaner
Assy (see p269). Therefore, if you replace the Ink System Unit, set a
new Wiper Cleaner Assy or move the part from the old Ink System
Unit to set it on the new one.
B
C
Ink System Unit
Hook
Plate
- Rear right -