Epson Stylus Pro 9900 - Page 274

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 274
Confidential
16. Disconnect four FFCs from the Printhead. See Figure 4-122.
17. Remove the three screws that secure the Printhead, and remove the Printhead. See
Figure 4-122.
E) Silver, Phillips, Bind machine screw M2x6 (bit: No.1): three pieces
Figure 4-122. Removing the Printhead
C H E C K
P O I N T
In the next step, to make it easier to remove the screw of the
Printhead it is recommended to use the long shaft screwdriver.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing or removing the Printhead.
<Adjustment Item>
1. Counter Clear (Printhead)
2. Head Cleaning
3. Head Rank ID
4. Nozzle Check
5. AID Function Check
6. Head PG Adjustment
7. Printhead Slant Adjustment (CR)
8. Printhead Slant Adjustment (PF)
9. Auto Uni-D Adjustment
10. Auto Bi-D Adjustment
11. Colorimetric Calibration (Color ID)
12. Print Image
FFCs
E
E
E
Printhead