Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 307
Confidential
DISASSEMBLING PROCEDURE
1. Remove the Control Panel. (p203)
2. Remove the IC Cover (L/R) and the IC Shaft Cover (L/R). (p206)
3. Remove the Maintenance Tank (L/R). (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
4. Remove the Right Cover. (p209)
5. Remove the Left Cover. (p209)
6. Remove the Top Cover. (p214)
7. Unlock the Carriage Unit and move it to the center. (p201)
8. Remove the Ink Tube Guide.
(
Step 7 in “4.4.5.6 Cutter Unit” (P. 257))
9. Remove the Cutter Cover.
(
Step 9 in “4.4.5.6 Cutter Unit” (P. 257))
10. Remove the Mid-Front Cover.
(
Step 10 in “4.4.5.6 Cutter Unit” (P. 257))
11. Remove the Ink Tube from the Ink Cartridge Cover R.
(
Step 8 to Step 16 in “4.4.6.5 Ink Cartridge Holder R” (P. 277))
12. Remove the two screws that secure the plate, and remove the plate.
A) Silver, Phillips, Bind P-tite M3x10: two pieces
13. Disengage the eight tube holders, and release the Ink Tube R.
14. Pull out the Ink Tube R from the two holes on the Main Frame.
Figure 4-163. Releasing the Ink Tube R
A
Tube holder
Ink Tube R
Hole
Hole
A
Ink Tube R
Plate
To Next Page
Loading...
