Epson Stylus Pro 9900 - Page 315

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 315
Confidential
4.4.7.3 Take-up Reel LED
1. Remove the Flange from the Auto Take-up Reel.
2. Remove the Take-up Reel Cover. (p313)
3. Disconnect the connector (CN1) on the Main Board.
4. Remove the four screws that secure the Power Supply Unit, and remove the Power
Supply Unit.
A) Black, Phillips, Bind S-tite M3x6: four pieces
5. Disconnect the connector (CN23) on the Main Board.
6. Release the harness from the cable guide, and remove the Take-up Reel LED.
Figure 4-173. Removing the Flange
Figure 4-174. Removing the Power Supply Unit
Figure 4-175. Removing the Take-up Reel LED
Flange
Auto Take-up Reel
A
A
A
A
Power Supply Unit
CN1
Main Board
Take-up Reel LED
Cable guide
CN23
Main Board