Epson Stylus Pro 9900 - Page 339

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 339
Confidential
4.4.8.13 LED
1. Remove the Color Measurement Device. (p325)
2. Remove the Mounter. (p327)
3. Remove the Front Cover. (p331)
4. Remove the Right Cover. (p328)
5. Disconnect the connector (CN23) on the Main Board.
6. Remove the two screws that secure the USB Housing, and remove the USB
Housing.
A) Black, Phillips, Bind machine screw M3x6: two pieces
7. Release the harness of the LED from the cable guide, and remove the LED.
Figure 4-212. Removing the USB Housing
Figure 4-213. Removing the LED
Make sure to route the harness as shown in the figure.
A
CN23
USB Housing
Main Board
LED
Routing
Cable guide