Epson Stylus Pro 9900 - Page 413

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT PF Related Adjustment 413
Confidential
ADJUSTMENT PROCEDURE
Adjust sensor (1) when using the paper thickness position tool 0.4/0.5, or when the
paper pressure rollers are locked and no adjustment jigs are available. Adjust sensor (2)
when using the paper thickness position tool 0.8/0.9, or when the paper pressure rollers
are unlocked and no adjustment jigs are available.
1. Loosen the screws (1 each) that secure the Paper Thickness Sensor Holder.
2. Slide the Paper Thickness Sensor Holder back and forth while watching the value
displayed on the panel. Stop the holder immediately after the target value is
displayed.
3. Secure the holder by tightening the screw(s).
Figure 5-71. Position Adjustment
C H E C K
P O I N T
Slide the Paper Thickness Sensor Holder toward you to increase
the value and slide it backward to decrease the value.
Paper Thickness Sensor Holder
Screws
1 2