Epson Stylus Pro 9900 - Page 456

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
MAINTENANCE Lubrication 456
Confidential
[Lubrication 7] [Lubrication 8]
Part Name Carriage Unit
Lubrication Point On the contact point of the CR Slider with the CR Guide Shaft
Lubricants G-84
Amount φ 2 x 3 mm x 4 points
Note Apply the grease to the points (in red) shown below.
Lubrication Point
Lubrication Points
Lubrication Point
Part Name Carriage Unit
Lubrication Point The holes (4 places) at both ends of the CR Unit rear side
Lubricants G-84
Amount 1.5 ± 0.1cc x 4 points (Right: x 2, Left: x 2)
Note
Apply the grease to the points (in red) shown below. Wipe off the
grease after the lubrication so as not to let it flow.
Lubrication Points
Lubrication Points