Epson TM-H6000IV

Chapter 2 Setup
55
2
Connecting the serial interface (RS-232) cable
1
Insert the interface cable connector firmly into the interface connector
on the connector panel.
2
When using connectors equipped with screws, tighten the screws to
secure the connectors firmly.
3
When using interface cables equipped with a grounding line, attach the
ground line to the screw hole marked “FG” on the printer.
4
Connect the other end of the interface cable to the host computer.
WARNING
Be sure to turn off the power supply for both the printer and host computer before
connecting the cables.
Use a null modem serial cable to connect the printer.