48
Chapter 2 Setup
2
Test Printing
After the printer setup or when the printer is not operating correctly, you can check the printer operation with
test printing. If the printer performs pattern printing following the steps below, the printer is operating
normally.
Test Printing on Roll Paper
Make sure all the covers are closed, and while pressing the Feed button, turn on the printer. After the printer
prints its status and the Paper LED flashes, press the Feed button again to restart the test printing.
Test Printing on Slip Paper
Make sure all the covers are closed, and while pressing the Release button, turn on the printer. After the Slip
LED flashes, insert the slip paper. If your printer is equipped with the endorsement printer, the printer prints
both sides of the paper.
Both types of test printing are completed when "*** completed ***" is printed.
To Next Page
Loading...
