Epson TM-H6000V - Self-Test Mode

72
Chapter 3 Advanced Usage
3
Self-test Mode
You can check the following items using the self-test.
 Product name
 Control firmware version
 Product serial number
 Interface information
 Customer display setting
 Built-in character fonts
 Automatic line feed setting
 Print density setting
 Usable device
 Recovery point information
 Maintenance information
 DIP switch settings
Follow the steps below.
1
Close the roll paper cover.
2
While pressing the Feed button, turn on the printer. (Hold down the Feed button
until printing starts.)
After printing the current print status, a Continuing self-test guidance is printed, and the
Power LED flashes.
3
Briefly press the Feed button (less than one second) to continue the self-test.
The printer prints a rolling pattern on the roll paper, using the built-in character set.
After “*** completed ***” is printed, the printer initializes and switches to standard mode.