63
Chapter 3 Advanced Usage
3
NV graphics memory capacity
Select one of the following.
None (0KB)/ 64KB/ 128KB/ 192KB/ 256KB/ 320KB/ 384KB (default setting)
Roll paper width
80mm (default setting)
58mm
Receipt print density
Selectable from 70% to 130% (5% increment)
Default setting: Depends on the DIP switch settings
The specified original paper types and recommended print densities are as indicated below.
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Be sure to install the roll paper guide (model: PG-58II) when you select the 58 mm paper width.
(See
"Changing the Paper Width" on page 54.)
Because some parts of the print head and the autocutter contact the platen and they may
become worn out in 58 mm printing, once you change the paper width from 80 mm to 58 mm,
you cannot change it back to 80 mm.
Original Paper type Density Print speed
AF50KS-E 4 (85%) 13 (300 mm/sec)
P220AGB-1 5 (90%) 13 (300 mm/sec)
TF50KS-EY 5 (90%) 14 (350 mm/sec)
P35524 6 (95%) 13 (300 mm/sec)
P160R, KT55FA 7 (100%) 14 (350 mm/sec)
TF60KS-EY, PD190R, KT48FA, F5041(55), F5041(48) 7 (100%) 13 (300 mm/sec)
P30521, P30523, P31523 8 (100%) 13 (300 mm/sec)
When the print density level is increased, print speed may be reduced. When printing at a
density of 115% or more and below a room temperature of 15°C, the speed drops to less than
200 mm/sec.
When setting the print speed to level 14, use customized values to set the print density.
To Next Page
Loading...
