117
Chapter 3 Application Development Information
3
Setting/Checking Modes
Besides the ordinary print mode, the printer has the following modes to set or check settings of the
printer.
•Self-test Mode
• Hexadecimal Dumping Mode
•NV Graphics Print Mode
•Receipt Enhancement Information Print Mode
•Software Setting Mode
Self-test Mode
You can confirm the following information by running the self-test mode.
•Control software version
•Receive buffer size
•Busy conditions
•Built-in character sets
•Print density
•Maintenance Information (Print head running length, count of autocutting)
Follow the steps below.
1
Close the roll paper cover.
2
While pressing the Feed button, turn on the printer. (Keep pressing the Feed
button until the printer starts printing.)
After the printer status is printed, the self-test printing continuance guidance is printed and
Paper LED flashes.
3
Press the Feed button for less than 1 second to continue the self-test.
Built-in characters are printed with rolling printing.
After printing "*** completed ***", the printer is initialized and enters the normal mode.
“Select Modes by pressing Feed Button.
Continue SELF-TEST : Less than 1 second
Mode Selection : 1 second or more”
To Next Page
Loading...
