Epson TM-U220-i Technical Reference Guide

82
Settings for Device Data Notification
To use the device data notification function with this product, you need to make the following
settings using EPSON TMNet WebConfig.
•Set the ID for the input device
•Set the target server
•Set the print message output when an error occurs
This section gives an overview of the setup procedure.
1. Connect this product to the network
Connect this product to the network and turn on the power.
2. Start EPSON TMNet WebConfig
On the setup computer, enter the following into the address bar of your Web browser to start EPSON
TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
( U "Starting EPSON TMNet WebConfig" on page 97
)
3. Set the Device Data Notification
Make the necessary settings from [Device Data Notification] on the [Web Service Settings] menu.
After making settings, click [Apply] at the bottom of the screen. The settings are saved to this
product. Settings are not enabled unless you click [Apply].
( U
"Web Service Settings - Server Access - Device Data Notification" on page 109)

Epson TM-U220-i Specifications

General

Type	POS printer
Color	Yes
Print technology	Dot matrix
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Maximum roll diameter	83 mm
Standard interfaces	Ethernet, Parallel, RS-232, RS-485, USB, Wireless LAN
Serial interface type	RS-232, RS-485
Connectivity technology	Wired & Wireless
Electromagnetic compatibility	VCCI class A, FCC class A, CE marking, AS/NZS 3548 class B
Mean cycles between failures (MCBF)	18000000
Safety	UL, CSA, TÜV (EN60950)
Mean time between failures (MTBF)	180000 h
Product color	Gray

Weight and Dimensions

Depth	248 mm
Width	160 mm
Height	138.5 mm