Epson TM-U220-i

137
Appendix
Appendix
Product Specifications
Printing method 9-pin serial impact dot matrix
Autocutter
*1
Cutting method By separated-blade scissors
Cutting type Partial cut (one point left uncut) (standard factory settings)
Full cut (completely cut off) (optional factory setting)
Interfaces USB host port  Standards: USB2.0 (High/Full/Low speed)
 Number of ports: 2 ports
 Connector: Type A
 Provided current: Within 500 mA for each port
Within 600 mA for both ports
USB device port  Standards: USB2.0 (High speed)
 Number of ports: 1 port
 Connector: Type B
Serial  Data transmission: Bit serial
 Synchronization: Asynchronous
 Flow control: XON/XOFF control or DTR/DSR control
 Signal levels: MARK = -3 to -15 V Logic "1"/ OFF
SPACE = +3 to +15 V Logic "0"/ ON
 Data format: Data length: 7 bits, 8 bits
 Stop bits: 1 or more
 Baud late: Maximum 115200 bps (bps: bits per second)
 Parity: Odd, Even, None
 Connector: D-sub 9 pin (Male)
microSD card  No. of slots: 1 slot
 Connector: Push-Push type
 Supported card: micro SD card, micro SDHC card
 Notes:
Make sure that the product power is turned off before insert-
ing or removing a microSD card.
Use a microSD card with wear leveling.
Ethernet 10Base-T/100Base-TX
Wireless LAN
*2
IEEE802.11b/g/n
Drawer kick  Pin: 6 pin
 Connector: Modular
(only for cash drawer)