NOTE
Adjustment of the lap belt
The lap belt can be adjusted to the body shape of the
user. For more information, see section
“7.6.1 Adjusting the Lap Belt” on page 44.
4.2.3. Accessories compartment
The accessory compartment is located under the seat and is used to store the charger and acces-
sories.
4.2.4. Armrests
The armrests serve to stabilise the user and each have a mounting device for the operating module.
Both armrests can be folded up to allow the user to enter from the side. To do this, turn the locking
lever on the side of the armrest by 180 degrees and push the armrest upwards. To fold down the
armrest, simply pull the joint forward and turn the locking lever back again.
NOTE
Maximum load on the armrests
The improper and one-sided loading of the armrests must be
prohibited.
4.2.5. Backrest
The backrest has Velcro straps to optimise the sitting position and a padded handle that allows the
wheelchair to be pushed. The backrest can be folded down to allow the wheelchair to be folded up.
You can adjust the Velcro straps of the backrest and the seat individually. To do this, loosen the
single loop. The tighter you pull the straps, the firmer the support effect.
4.2.6. Operating module
The operating module is used to control the wheelchair and can be mounted on both armrests. It
consists of function keys and a joystick.
A Joystick F Horn
B Decrease speed G "On" button
C Speed display H Charge level display
D Increase speed I "Off" button
E Charger connection
Image 2: Overview of the operating module
A
B
C
D
E
G
F
H
I
ergoflix.de | 21
To Next Page
Loading...