Hardware Control and Troubleshooting
To view the results, see Results from an ODD Session.
3.13.2 Return Line Card to the In-Service State
After testing a line card, you must return it to the in-service state. To return the
line card to the in-service state from the ODD state, you must enter the no form
of the on-demand diagnostic and shutdown commands.
Table 74 Return a Line Card to the In-Service State
Task Command Notes
Access global configuration mode.
configure
Enter this command in exec mode.
Specify the card that was tested and access card
configuration mode.
card
Specify the card type and slot number.
Remove the card from the ODD state and put it in the
out-of-service state.
no on-demand-diagnostic
Return the card to the in-service state; restore any
cross-connections.
noshutdown
This command restores any
cross-connections to their state at the
time of the shutdown.
Commit the previous commands to the database and
return to exec mode.
end
Note: If you intend to reload the card, using the reload card in exec mode,
you must first remove the card from the ODD state.
3.13.3 Results from an ODD Session
Table 75 LED States During and After an ODD Session
Card State State of LEDs
Out of service (shutdown command) FAIL, ACTIVE, and STDBY LEDs are off.
ODD (on-demand-diagnostic command) FAIL, ACTIVE, and STDBY LEDs are off.
Session in progress FAIL, ACTIVE, and STDBY LEDs blink.
End of session with one or more failures FAIL LED is on; ACTIVE, and STDBY LEDs are turned off until card is returned
to the in-service state.
End of terminated session FAIL, ACTIVE, and STDBY LEDs are turned off until the card is returned to the
in-service state.
End of successful session FAIL, ACTIVE, and STDBY LEDs are turned off until the card is returned to the
in-service state.
To display the results from one or more ODD sessions, perform one of the
tasks listed in Table 76; all commands are entered in any mode.
Table 76 Display Results from ODD Sessions
Task Command
Display results for all components from the last initiated
session.
show diag on-demand
Display results for a line card.
show diag on-demand card slot
8527/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
