Escea DS1150 - D Installing the Electricity and Gas to the Appliance; D1 Power Supply; D2 Pairing Fireplace to Escea Smart Heat App

23
630791 DS MKII INSTALLATION MANUAL
D INSTALLING THE ELECTRICITY AND GAS TO THE APPLIANCE
D1 
Before the Fireplace is installed, consideraon must be given to the locaon of an appropriate power supply. An
earthed 230/240 volt mains power connecon (typically a standard 3 pin outlet) must be available within 1m of
the boom right of the appliance.
This connecon must be accessible aer the heater has been fully installed so that the appliance can be safely
disconnected from the mains power supply prior to servicing.
A mains isolaon switch (compliant to AS:NZS 5601 Clause 6.2.8) which is accessible from outside the cavity can
also be used to disconnect the power.
Regardless of the method used, it MUST ALWAYS be possible to safely isolate the electrical supply to the
appliance aer it has been fully installed.
This appliance must not be located immediately below a socket outlet. This appliance will draw a maximum of 2
Amps from a 230/240 V supply. No addional power supply is required for the power ue.
An electrical wiring diagram is located underneath the electronic tray, on the rear of, and also in the rear of this
manual (Secon S15 on page 69).
D2 
Download and install the Escea Smart Heat App
Ensure the replace and remote have been powered on, then follow the on screen instrucons (see below) to
connect the unit to the app.
