Escea DS1150 - F10 Fitting the Linear Trim; F11 Fitting the Bevelled Lite Fascia

F
52
630791 DS MKII INSTALLATION MANUAL
F10 
To install the Linear Trim onto the DS Series, slide the boom of the trim along the gib trim and push it in ush
with the wall cladding. It should slide in on all four sides and t by fricon inside the black reveal (the top should
be above the top of the black reveal).
Note: If the fricon t is loose, please use the provided ber tape along the boom edge of the linear trim to
ghten the t.
F11 
To avoid scratches to the fascia panels of this heater, they must be ed at the conclusion of the installaon
process, aer wall linings are in place.
Note: Never rub the fascia.
1. Ensure the plasc spacer is placed on the thread of the studs.
2. Screw and ghten the 4 studs with spacers onto the back of the fascia.
3. Rivet the 4 spring clips onto the bracket on top of chassis of the
appliance.
4. Aer the 13mm thick wall has been nished, the fascia clips onto the
appliance.