Escea DS1150 - Page 32

E
32
630791 DS MKII INSTALLATION MANUAL
WARNING!
TURN THE GAS AND POWER SUPPLIES OFF.
Follow the instrucons outlined in secon "E5 Checking the Gas Operang Pressure" on page 28 to access the
burners, jets, and regulator.
Change the burner jets and the pilot jet to those supplied in the kit set (see table above).
NOTE: Ensure the pilot jet is joined up to the olive before inserng the jet into the pilot assembly (as shown
below).
Change the burner collars to the ones supplied in the kit set (see table above).
Screw out the nylon adjuster screw inside the regulator to remove the exisng spring. Replace the spring with
the one supplied in the conversion kit and reassemble the regulator.
Sck the new gas type label supplied in the kit set on the underside of the tray hatch. Ensure the serial number
and date of manufacture are sll visible. Write your name, company (if appropriate) and date of conversion on
the new label with permanent marker.
Ensure the gas supply is sll OFF, turn the power supply ON.
Change the operang pressure.