eSolutions eProWallbox - Instructions for Use; Preliminary Charging Operations

23
User Manual
6 INSTRUCTIONS FOR USE
6.1 Preliminary charging operations
Beforestartinganewchargingsession:
• Ensure the appliance and its connectors are perfectly intact, dry, and free
of any impurities.
• Donotinsertngersorobjectsintothesocket.
• Do not touch the appliance or any of its extensions with wet hands or bare feet.
• Makesuretheapplianceisnot,andhasnotbeen,exposedtoheatsources,
explosiveorinammablesubstances.
• Ensure the electric vehicle is compatible with the appliance’s technical features.
• Vehicle adapters must not be used to attach a connector to a vehicle socket.
• Adaptersbetweenthevehiclesocketandplugshouldonlybeusedifspecically
designated and approved by the vehicle manufacturer or the manufacturer
of the electric vehicle’s power supply equipment, in accordance with national
requirements. Such adapters must, however, comply with the requirements
of the IEC 61851-1 standard and other relevant standards governing both the
plug and socket of the adapter. The adapters must in any case be marked with
specicindicationsforusepermittedbythemanufacturer(e.g.IEC62196).
WARNING
DO NOT remove the charging connector from the electric vehicle
during the entire charging process. Only remove the charging
connector from the vehicle when charging operations have ended
or have been halted following the appropriate procedure. In either
case, undue force must not be used.