Choose to create or not create a small or large chamfer on the rear surface of the lens.
“Super Chamfer” is not available for the high-base bevel finish.
For more information, consult the section Edging a lens > Perform a polishing (F p.67) and Edging a
lens > Perform a chamfering (F p.67).
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The high-base bevel finish “automatic trajectory” screen is displayed by default.
By default, the edger shows the values corresponding to the frame material (metal or plastic).
Check and modify these values according to the thickness of your lens and your frame.
You can:
• produce a high-base bevel in mode “automatic trajectory”, (F p.36)
• high-base bevel in “front surface tracking” mode. (F p.37)
To Next Page
Loading...