EQT Router User Manual
Revision 1.9.1 Page v
5.8. GENERAL FAULT PARAMETERS ................................................................................... 44
5.9. CLEAN SWITCH OUTPUT MODULE CONTROL PARAMETERS (–CS VERSIONS
ONLY).............................................................................................................................. 45
5.10. CLEAN SWITCH OUTPUT AUDIO CONTROL PARAMETERS (–CS VERSIONS
ONLY).............................................................................................................................. 46
5.11. CLEAN SWITCH OUTPUT AUDIO MIXER PARAMETERS (–CS VERSIONS ONLY) ........ 47
5.12. CLEAN SWITCH OUTPUT FAULT PARAMETERS (-CS VERSIONS ONLY) .................... 48
6. CONFIGURING THE SYSTEM USING WINSETUP ............................................................. 49
6.1. COMMUNICATION PORT SETUP .................................................................................... 53
6.1.1. Control Panel Ethernet Interface ............................................................................ 53
6.1.2. Control Panel Q-Link Interface ............................................................................... 54
6.1.3. Serial Interface ...................................................................................................... 55
6.1.4. Ethernet Interface.................................................................................................. 55
7. UPGRADING FIRMWARE ..................................................................................................... 57
7.1. UPGRADING A STANDARD EQT .................................................................................... 57
7.2. UPGRADING –CS VERSIONS OF THE EQT .................................................................... 59
7.3. UPGRADING FROM OLDER VERSIONS OF FIRMWARE ................................................ 60
To Next Page
Loading...
Need help?
General
