EQT Router User Manual
Revision 1.9.1 Page i
REVISION HISTORY
REVISION DESCRIPTION DATE
0.1 Preliminary Version Aug 2008
1.0 Added –F Fiber version information Oct 2008
1.1 Updated Specifications May 2009
1.2 Added panel configuration information Jun 2009
1.3 Revised configuration information and added 16x16 and 16x4 versions Mar 2010
1.4 Removed references to using Q-Link to connect frames
in Manual Remote Control section July 2011
1.5 Added –CS Clean Switch version information Aug 2011
1.6 Updated “RS-422 Pin Out” table Jun 2012
1.7 Added NEBS documentation Oct 2012
1.8 Updates throughout May 2013
1.8.1 Added additional NEBS warning re shielded Cat-5 cables May 2013
1.8.2 Updated Cable Equalization information Jul 2013
1.9 Updates throughout Dec 2013
1.9.1 Updated notes and figures Jan 2014
Information contained in this manual is believed to be accurate and reliable. However, Evertz assumes no responsibility for the use thereof nor
for the rights of third parties, which may be affected in any way by the use thereof. Any representations in this document concerning
performance of Evertz products are for informational use only and are not warranties of future performance, either expressed or implied. The
only warranty offered by Evertz in relation to this product is the Evertz standard limited warranty, stated in the sales contract or order
confirmation form.
Although every attempt has been made to accurately describe the features, installation and operation of this product in this manual, no
warranty is granted nor liability assumed in relation to any errors or omissions unless specifically undertaken in the Evertz sales contract or
order confirmation. Information contained in this manual is periodically updated and changes will be incorporated into subsequent editions. If
you encounter an error, please notify Evertz Customer Service department. Evertz reserves the right, without notice or liability, to make
changes in equipment design or specifications.
To Next Page
Loading...
Need help?
General
