Need help?Do you have a question about the Evil Mad Scientist AxiDraw V3 and is the answer not in the manual?
General| Model | AxiDraw V3 |
|---|---|
| Manufacturer | Evil Mad Scientist Laboratories |
| Type | Pen Plotter |
| Repeatability (Precision) | 0.1 mm |
| Connectivity | USB |
| Pen Lift Mechanism | Servo |
| Compatibility | Windows, macOS, Linux |
| Software | Inkscape |
| Power Supply | 5 V DC |
| Supported Media | Paper, cardstock |
Step-by-step instructions for unboxing and connecting the AxiDraw.
Essential safety guidelines for operating and moving the AxiDraw.
Guide to downloading and installing the necessary software on your computer.
Manual steps to move the AxiDraw carriage to its starting position.
Instructions for connecting the AxiDraw to power and your computer.
Testing the pen lift mechanism using AxiDraw Control.
Guidance on how to properly insert and tighten a pen in the clip.
Methods for aligning paper on the work surface.
Steps to open a document and initiate the first plot.
Instructions for using the included easel to hold paper.
How to set the pen clip for vertical or angled placement.
Setting the vertical travel range for the pen.
Using the Plot tab to initiate a drawing job.
Managing active plotting jobs.
Steps to restart a plot after pausing.
Procedure to stop and reset a plot.
Organizing plots using Inkscape layers.
Plotting specific layers based on naming conventions.
Adjusting writing, pen-up, and acceleration speeds.
Controlling the vertical movement speed of the pen.
Simulating plots without physical interaction with the AxiDraw.
Settings for reordering elements to reduce plotting time.
Directly moving the AxiDraw's X and Y axes.
Manually raising or lowering the pen.
Specifying the AxiDraw model for correct operation.
Querying and installing the latest software and firmware.
Troubleshooting the pen lift motor and carriage position errors.
To Next Page