9
2. Checking out your AxiDraw
2.1 Parts and accessories
Here are the parts that come with AxiDraw:
1. The AxiDraw itself
2. Clip Easel and binder clips (4 on AxiDraw V3, 8 on larger models)
3. Plug-in power supply
4. USB cable
5. Hex drivers and wrenches
Sizes include 2 mm, 2.5 mm, and 3 mm hex drivers, and low-profile 8 mm
and 10 mm wrenches. Of these, only the smallest (2 mm) hex driver is
used in regular operation. The rest are normally not needed.
6. Rubber bands
These can be used to add a little extra pen-down force if needed.
See the last chapter, AxiDraw Tips and Tricks.
7. Not shown: Extra rubber feet (AxiDraw V3 and V3 XLX only)
Normally not needed. But, just in case a rubber foot gets bumped o of
the base during shipping, spares are included.
8. Not shown: Special accessories included with AxiDraw SE/A3
The SE/A3 also includes an XL pen clip and an italic pen adapter.
These are available separately for use with other AxiDraw models.
To learn more about available AxiDraw accessories, please visit: emsl.us/902
Power
supply
USB Cable
Clip
Easel
Binder clips
1. AxiDraw
Hex drivers and wrenches
To Next Page
Loading...
Need help?
General