54
9.8.3 Enable Motors, Disable Motors
These two commands either energize the two stepper motors or turn power o
to them. The carriage can be moved by hand only when the power to these mo-
tors is o.
9.8.4 Enter EBB Bootloader Mode
Command the EBB to enter “bootloader” mode. This utility mode is sometimes
used in reprogramming the firmware. If you should accidentally enter this mode,
disconnect the AxiDraw from both power and USB to reset it.
9.8.5 Strip plotter data from file
The AxiDraw software stores certain configuration data within your document.
While having that data there does not cause any known issues, this command can
strip that data from the file, should that need arise.
To Next Page
Loading...