33
Once you are familiar with the process of inserting the pen and setting the
height, this whole process is described by two quick steps:
1) Raise the pen holder to the pen-up position.
2) Insert your pen, just above the paper.
The pen-up and pen-down heights in the Setup tab may each be adjusted be-
tween 0 and 100% to suit your needs. Higher percentage values lift the pen high-
er.
The factory-default values of 60% (up) and 30% (down) are a good starting point.
You may also wish to try adjusting them to a dierent set of values (say, 80% and
50%, respectively) and apply, to see that the positions change when you adjust
them and toggle the pen position.
To Next Page
Loading...
Need help?
General