Digit 8
Press this key to output the displayed values via the built-in interface to
a printer or a computer.
Digit 5
In Target weight mode, press this key to preset the allowable “Range”
value.
Digit 2
In Limit weight mode, press this key to input “Low” value, so that the
weighing result cannot be smaller than this value.
Press this key to store HI, LO, OK and Range settings or exit the
settings mode.
Digit 7
Press this key to switch among Simple weight mode, Limit weight
mode and Target weight mode.
Digit 4
In Target weight mode, press this key to input value which meets the OK
requirement.
Digit 1
In Limit weight mode, press this key to input “HI” value, so that the
weighing result cannot be greater than this value.
Digit 0
Press this key to switch the weight unit, the icons or arrows will indicate
the enable units as appropriate. The units available are dependent on
the exact scale model.
After power off, the scale will memorize the enable units. When the scale is
powered on again, it displays the previous enable units.
To Next Page
Loading...
Need help?
General
