METALJET D2+ INSTALLATION
Revision 19, November 2016 Page 4-27
4.5 Operating conditions
The MetalJet D2+ source may only deliver optimum performance if the following operating conditions are
respected.
4.5.1 Ambient conditions
See Chapter 11
The MetalJet D2+ source should not be placed in a space where it may be exposed to direct sunlight,
atmospheric agents (rain, snow, ice, etc.), dust, or aggressive gases.
Do not install or use the MetalJet D2+ source in explosive environments or those with a high fire risk.
4.5.2 Ventilation
Do not block the air intakes of the source head, pump box and two electronics rack modules.
4.5.3 Cooling water
See Chapter 11
To Next Page
Loading...