Preparing for Automation
224 FTB-500
Preparing to Control Modules with a Dedicated Application
5. Set the parameters:
Select Remote Control to be able to access the module emotely
(via TCP/IP over Telnet or other).
Select Standalone to leave the module active even if all users
close their dedicated applications.
Note: When a standalone module is no longer used, you can simply release it.
See the corresponding procedure below to know how to proceed.
6. If desired, under Description, type a description that will help you
identify the instrument.
Note: You can enter up to 10 characters. The description can correspond to the
test interface ID or to any other short text of your choice.
To Next Page
Loading...
