Communicating Through TCP/IP over Telnet
412 FTB-500
Configuring Your Unit and Modules to Work With TCP/IP over Telnet
7. If necessary, under LINS, modify the logical instrument number that
you will use to access the instrument remotely.
Note: If the LINS column is empty, it means that the corresponding module
cannot be controlled using SCPI commands.
8. Tap or click Apply to confirm your changes or OK to apply your
changes and close the window.
Note: This information will be updated the next time you start the module
application, or set Instrument Control in remote mode. Refer to the
corresponding module documentation for more details.
To Next Page
Loading...
