Extron electronics TouchLink - Rendezvous by NFS Setup; Calendar Setup; Panel Setup

Room Scheduling System • Rendezvous by NFS Setup 79
Rendezvous by NFS
Setup
Calendar Setup
Figure 97. Selecting the Rendezvous by NFS Calendar
1. Select NFS from the Select a Calendar Type drop-down list (see figure 97,
1
).
2. Select a protocol (either https:// or http://).
If you use https:// the Proxy Server must be setup as “TLS Pass Through”. This is
required for the TLS to validate the calendar server’s SSL certificate (see Setting up a
Proxy Server
on page 82).
3. Enter the address of the NFS server.
Panel Setup
The following column headings are available for touchpanels with the Rendezvous by NFS
calendar:
• Status — Use this check box to select individual panels for configuration.
• IP Address — This cell contains the IPaddress of the touchlink panel.
• Hostname — The host name is a fully qualified domain name that uniquely identifies
the computer. It is required for the computer to communicate with other devices on the
network.
• Room Name — This is the name that appears on the touchscreen, once it is
configured.
• User Name — this is the user name for an account with access to the NFS server. It is
typically an administrator account.