FAAC A952 - Adjusting the Integrated Mechanical Opening Stop

A952 43 532310 - Rev.A
34
35
36
3.14 ADJUSTING THE INTEGRATED MECHANICAL OPENING STOP
The A952 is fitted with an integrated mechanical stop that limits the opening stroke.
1. Open the door to the position at which you want the internal stop to operate.
2. Turn the screw in the cam according to the direction of rotation of the gearmotor shaft in order to reach
the position, as shown in 34.
3. Insert the cam onto the shaft so that the screw is as close as possible to the mechanical stop used (35).
4. If the screw is slightly too far away from the mechanical stop because of the pitch of the teeth on the shaft,
it can be adjusted using an Allen key (35).
5. When finished, screw in the locking cap (36).