A952 44 532310 - Rev.A
3
3
1
1
2
2
37
1
2
3 4
38
3.15 INSTALLING THE SIDE COVERS
With reference to 37:
1. Partially tighten the two M5x10 self-tapping screws (1) at both ends of the support plate.
2. Insert both sides as far as they will go, inserting the guides (2) into the seats on the support plate, and the
slots under the heads of the screws.
3. Tighten the screws (3).
3.16 INSTALLING THE SIDE FUNCTIONS SELECTOR
L
Install the selector after having installed the battery kit, if provided.
With reference to 38:
1. Open the access cover on one of the side covers by gently prising it open at the point indicated.
2. Remove the pre-cut section of plastic using a cutter.
3. Press the selector into the rectangular opening so that position 1 (indicated by the line) is facing upwards.
4. Apply the sticker with the number 1 facing upwards.
5. Plug the cable into the "SEL" connector (41)
To Next Page
Loading...
