FAAC A952 - Connections

A952 47 532310 - Rev.A
-
-
1 2 3 4 5 6
7 8 9
10 11 12 13 14 15 16 17 18 19
20212223242526
RXTX
V
G
J14
- COM
- COM
- COM
- COM
+24 V
IN8
IN7
IN6
IN5
IN4
IN3
IN2
IN1
- COM OUT 1 OUT 2 +24 V
COM COM
OUT 3
NO
OUT 4
NC
J12
J16
43
COM NO NC
OUT 5
LOCK
4.2 CONNECTIONS
CONTROL DEVICES
The control devices must be fitted with an open (NO)
or closed (NC) contact according to the input to which
they are connected. The device contact is connected
to the input to which they refer (IN1-IN8) and the
common negative (- COM).
L
Multiple NO contacts on the same input must be
connected in parallel.
Multiple NC contacts on the same input must be
connected in series.
The function and type of contact (NO/NC) can be pro-
grammed for all inputs. The default programming
functions are indicated below:
Default programming
Type of
contact
10 IN1 INTERNAL OPEN NO
11 IN2 EXTERNAL OPEN NO
12 IN3 EMERGENCY CLOSE NC
13 IN4
CLOSING SAFETY DEVICE NC
14 IN5 OPENING SAFETY DEVICE NC
15 IN6 KEY NO
16 IN7 FIRE ALARM NO
17 IN8 AUTOMATIC OPEN NO
A LED next to each input indicates its status:
- LED on: input closed towards negative
- LED off: input open
OUTPUTS
The A952 has 5 outputs on which both the function
and type of contact (NO/NC) can be programmed.
The outputs are activated according to the pro-
grammed function and are of the type:
- Open Collector (OUT 1 and OUT 2)
OUT active OUT not active
NO contact 0 V" circuit open
NC contact circuit open 0 V"
Do not exceed the maximum load of 100 mA for each
output.
- Relay (OUT 3 , OUT4 and OUT 5)
OUT active OUT not active
NO contact circuit closed circuit open
NC contact circuit open circuit closed
The maximum contact rating for each contact is 0.5
A 24 V
"
.
The default programming functions are indicated
below:
Default programming
Type of
contact
4 OUT 4 DOOR NOT CLOSED NO
6 OUT 3 DOOR OPEN NO
21 , 22 OUT 5 RED TRAFFIC LIGHT EXT NO
23 OUT 1 GONG NO
24 OUT 2 TEST NC