A952 60 532310 - Rev.A
10. ACCESSORIES
3. Check that the devices are working properly.
BUS 2EASY DEVICE REGISTRATION
Registration is required:
- When the automation is first started or after the
board has been replaced
- Following any changes (addition, replacement or
removal) of BUS 2easy devices
Board registration procedure:
1. Select function
bu in programming. When ll
is released, the display shows the status of the
BUS 2easy devices:
no
No device registered
-
At least one device registered
cc
BUS 2easy line short-circuited *
Er
BUS 2easy line error
* Registration is not possible in this condition.
2. Press and hold the
pp and qq buttons simultane-
ously for at least 5 s until
Y appears. The regis-
tration is complete.
3. Release the
pp and qq buttons. The display shows
the status of the BUS 2easy devices.
4. Check the status of the LEDs on the display.
Registration procedure from KP EVO:
access the Programming/Installation/2 Easy Reg menu.
CHECKING REGISTERED DEVICES
1. Select the function bu in basic programming. Af-
ter registering one or more devices, segment 13 on
bu is on; when a device is activated, the segment
corresponding to the command lights up:
8 8
13
1
2
1 Total opening command
2 Partial opening command
13 At least one device registered
2. Press and hold the
pp button; the segments relative
to the registered devices will light up.
10.1 BUS 2EASY DEVICES
Single channel FAAC BUS 2easy control devices can be
connected to this board.
L
If no BUS 2easy accessories are used, leave the con-
nector free. Do not bridge.
CONNECTION
BUS
2 Easy
BUS
2 Easy
BUS
2 Easy
BUS
Connect the BUS 2easy devices to the BUS connector.
L
The overall length of the BUS 2easy cables must not
exceed 100 m.
The BUS line does not require a matching polarity
connection.
BUS 2EASY CONTROL DEVICES
1. Position the DIP switches to assign the commands.
L
For each control device connected to the BUS 2easy
line, position the DIP switch switches so that only one
command is used on a single device.
DIP switch
1 2 3 4 5
command
0 0 0 0 0 AUTOMATIC OPEN
0 0 0 1 0 EXTERNAL OPEN
0 0 1 0 0 INTERNAL OPEN
0 0 1 1 0 SEMI-AUTOMATIC OPEN
0 1 0 0 0 KEY
0 1 0 1 0 NOT USED
0 1 1 0 0 NOT USED
0 1 1 1 0 NOT USED
1 0 0 0 0 NOT USED
1 0 0 1 0 PARTIAL AUTOMATIC OPENING
1 0 1 0 0 PARTIAL EXTERNAL OPENING
1 0 1 1 0 PARTIAL INTERNAL OPENING
1 1 0 0 0 PARTIAL SEMI-AUTOMATIC OPENING
1 1 0 1 0 PARTIAL KEY
1 1 1 0 0 NOT USED
1 1 1 1 0 NOT USED
2. Register the control devices BUS 2easy (Function
bu in basic programming).
To Next Page
Loading...
