150
CARE AND MAINTENANCE
Replacing pressure filter
A soiled pressure filter (A) is indicated by a
warning message (see also FAULTS AND
REMEDIAL ACTIONS Section 1.1). Replace the
filter element as soon as possible, but not later
than every 1000 operating hours.
Operation_Pic_number:1
Text-module
● Unscrew the filter housing (A).
● Withdraw the filter element from housing.
● Replace the filter element, do not wash out.
● Lightly oil the sealing rings.
● Put filter housing back in place and tighten
screw (to 40 Nm).
Replacing intake filter
Operation_Pic_number:1
● Remove cover (A) and extract the intake filter.
● Replace the spin-oil filter.
Fig.33
Fig.34
Filling gear oil
Operation_Pic_number:1
● Remove dipstick (A) and pour oil through the
filler hole.
10.2 Checking the transmission
oil level
● Tractor must be on level ground.
● Twist the dipstick and pull out.
● Wipe the dipstick using a clean, fibre-free rag.
● Reinsert dipstick fully and twist into place.
● Twist the dipstick and remove again.
The oil level must reach the upper notch on the
dipstick.
Difference in oil volume between min. and max.
marks on dipstick is approx. 3 litres.
Fig.35
To Next Page
Loading...
Need help?
General
