60
OPERATION
14. Power lift and PTO
automatic mode
14.1 Power lift automatic mode
Automatic mode allows the control of the rear
and front power lift to be transferred to the but-
tons on the joystick.
If the basic settings are not suitable, any setting
can be selected with the Variotronic TI.
Activating the automatic function
Operation_Pic_number:1
● Unlock power lift (see also OPERATION Sec-
tion 18.2).
● Depth control (O) front, and (G) rear.
NOTE:
The automatic function can be by-passed
with the fast lift switches (H) or (P).
Example:
Lifting gear set to automatic function, fast lift
switch to Lift, lifting gear raised. The lamps
next to automatic mode buttons (N) and (S)
remain lit.
Automatic mode only becomes active again
when Quick Lift switches (H) or (P) are at cen-
tre position.
Button (N), automatic rear power lift
function ON/OFF.
Button (S), front power lift automatic
mode ON/OFF.
The automatic function can be deselected at any
time.
Fig.102
Using automatic mode
Operation_Pic_number:1
● Button (A1), the front power lift goes into
'Control' mode.
● Toggle switch in direction (B1), the rear power
lift goes into 'Control' mode.
Power lift is lowered to the value set using depth
control (G or O, see OPERATION Fig. 104).
Text-module
● Button (A2), front power lift goes into 'Raise'
mode.
● Press rocker switch in direction (B2), rear
power lift goes into lift mode.
Power lift rises to the set upper limit.
● Stop button (C), power lift (front/rear) remains
at the current position.
The power lift can now be moved using the but-
tons.
Text-module
NOTE:
The external Raise/Lower buttons on the
front and rear of the tractor remain active,
and have priority even with the automatic
mode active.
If the lifting gear is moved with the external
control buttons, the EPC is locked and auto-
matic mode must be switched on again.
Fig.103
To Next Page
Loading...
Need help?
General
