156
CARE AND MAINTENANCE
Temperature warning device
Operation_Pic_number:1
If oil temperature is too high, this is indicated by
a warning message, (see also FAULTS AND
REMEDIAL ACTIONS Section 1.1).
Function check:
● Detach cable connector (A) from the tempe-
rature switch and connect to ground.
● Turn ignition key to position 'I'.
Operation_Pic_number:1
'Hydraulic oil temperature' symbol is shown on
multiple display, with warning lamp flashing and
intermittent tone.
14. Steering
Regularly check the steering for leaks and signs
of damage, check that the sealing bellows are in
good condition, and check the hoses for chafing
marks.
Fig.50
Fig.51
15. Front wheels
15.1 Checking toe-in
After initial 50 operating hours, then every 500
operating hours.
Operation_Pic_number:1
Toe-in should be 0 - ±1 mm.
● Steering straight ahead; Average axle load.
● Measure distance between tyres on the
wheel hub at the front rim flange (A).
● Push tractor forward by 1/2 turn of the front
wheels.
● Measure distance between tyres on the
wheel hub at the rear rim flange (B).
Fig.52
To Next Page
Loading...
Need help?
General
